- BACK
- Rear suspension donut bush.
- Symptoms of failure, knocking suspension whilst accelerating left or right.
- Very common, however mine was not showing this problem too much.
- Below shows the new replacement with the extra washer that sits between
- the arm and chassis. If you are lucky Ian Marsh might have some stock left
- over from a group buy. Senator3024v@hotmail.com
- Support the cross member arm with a jack, undo and remove the 3 bolts holding the support bracket.
- Remove the long bolt through the centre of the bush. Prize the bush out of it's socket with a large
- screwdriver.
- The new bush will easily push into the holder in the arm, the spacer washer fits over the top between
- the chassis and cross member.
All bolted back up.
- The other side is exact same procedure (my nearside), however this was a surprise as this bush had
- completely failed, the aluminium insert had become unstuck from the rubber completely.
